HELIX HLT3000 - Page 7

3/ ASSEMBLY
- 7 -
Step 4:
Align the bolt holes on the pedal frame with the bolts on the yoke of the
Crank arm. There is an indentation on the Pedal Frame and a protrusion on
theyoke.TheseshouldttogethertoallowthePedalFrameandyoketo
becomeevenandushwitheachother.
Whileholdingtheframeinplace,rstinstallthetopboltpartiallytoallow
the pedal frame to “hang” on that bolt. Now partially install the bottom
left and bottom right bolts. Slowly tighten all the bolts until the two parts
become perfectly aligned to each other with no space between the parts.
Thenrmlytightenallthreebolts.RepeatfortheotherPedalFrame.
Step 5:
Place the Pedal Covers on the Pedal Frames and align to allow the frame to
tinsidethecavitiesonthebottomofthePedalCovers.
Install2PedalCoverBoltsineachPedalFrameandsecurermly.Thereis
noneedtoovertightenthesebolts.Theyshouldbermbutnotexcessively
tightened.
Separate the Pedal Covers from the Pedal Frames as shown.
A5-HLT3000 v3 proofed.indd 7 01/02/2011 10:21