HELIX ULTIMATE P SIX DSP

28
ACO platform features
Beside the unique DSP sound e󰀨ects the
P SIX DSP ULTIMATE provides a bunch of new
system and DSP features.
In the DCM menu of the DSP PC-Tool software in-
dividual settings can be made for several of these
system features.
Turn On & O󰀨 Delay
This function allows to determine the delay time
with which the integrated DSP is switched on and
o󰀨. The factory setting is 0.2 seconds. The delay
time should only be modied if there are e.g. nois-
es while switching on / o󰀨 the amplier.
URC Setup Switch Conguration
The ACO provides ten internal memory locations
for sound setups instead of the common two.
By using an optional URC remote control or the
Control pushbutton (see page 18, point 1) it is
possible to toggle between two of the ten mem
-
ory locations. These two memory locations can
be determined in the “URC Setup Switch Cong
-
uration”. The memory locations one and two are
preassigned by default. To switch between all in
-
ternal memory locations, the optionally available
remote controls DIRECTOR and CONDUCTOR
are recommended.
Remote Output Conguration
This function controls if the remote output (which
switches on and o󰀨 the connected ampliers) will
be temporarily deactivated during a sound setup
switch. This function is activated (ON) by default.
ADEP.3 Conguration
If the P SIX DSP ULTIMATE is connected to an
OEM radio via the highlevel inputs it may happen
that the ADEP.3 circuit has to be adapted to the di-
agnostic mode of the radio if the latter is equipped
with a so-called “class SB” output stage”.
In the “ADEP.3 SB compatibility mode & Advanced
Noise Suppression” section, an adjustment should
be made if there are e.g. distortions occur in the
upper volume range.
The compatibility mode is disabled by default.