Why does my HemoCue Measuring Instruments show Err30?
The Err30 error code on your HemoCue device may appear due to: 1. Dirty optical parts: Clean the optical parts after turning off the analyzer. 2. Wet optical parts after cleaning: Allow 15 minutes for the parts to dry before turning the analyzer back on.
What to do if HemoCue Measuring Instruments shows Err01?
If your HemoCue Measuring Instruments displays Err01, it could be due to: 1. A measurement error: Take a new microcuvette and repeat the measurement. 2. An abnormal sample: The blood sample should be verified with a suitable laboratory method and be questioned as to the pathological condition of the patient.
Details the system's purpose for quantitative WBC determination and safety precautions.
Lists and describes the HemoCue WBC Analyzer and its associated components for setup.
Instructions for powering on, self-test, and readiness indicators.
How to activate or deactivate the audible signal for measurement alerts.
Procedure for connecting and using the printer to output results automatically.
Step-by-step guide for collecting capillary blood and preparing it for analysis.
Instructions for using control materials or venous blood samples for analysis.
Daily maintenance steps for cleaning the cuvette holder and cover.
Procedure for cleaning the analyzer's optical parts using the HemoCue Cleaner WBC.
Lists common error codes, their explanations, and recommended actions for resolution.
Troubleshooting steps for display errors, no characters, or cuvette holder movement problems.
Details the system's purpose, methodology, and operating principles.
Recommendations for storage, handling, and required materials for operation.
Information on internal quality control, self-tests, and expected blood cell count ranges.
Data on linearity, precision, and limitations of the measurement method.
Presents results from validation studies comparing HemoCue WBC to other methods.
Details substances that do not interfere with HemoCue WBC system performance.
Guidelines for operation in electromagnetic environments and compliance with EMC standards.
Specifications for AC adapters and warnings regarding electromagnetic interference.
Procedures for analyzer service, disposal, and available spare parts.
General| Sample Volume | 10 µL |
|---|---|
| Operating Temperature | 15 - 30 °C |
| Sample Type | Capillary, venous or arterial whole blood |
| Measurement Range | 0.3 - 30 x 10^9/L |
| Analysis Time | 3 minutes |
| Power Supply | AC adapter |
| Calibration | Factory calibrated, no user calibration required |
| Humidity | 10-90% non-condensing |
| Storage Temperature | 0 - 50 °C |
To Next Page
