21
EN
EMPTY TRAY
INSTALL TRAY
FILL BEANS
LACK OF POWDER
PRESSURE HIGH
TEMPERATURE HIGH
TEMPERATURE LOW
FILL WATER TANK
EMPTY GROUNDS
UNIT EMPTY
BREW UNIT STUCK
Causes Solutions
If the water drip tray is full, any function of
making beverage will be out of service.
Take the drip tray out, empty the
waste water in the drip tray and
reinstall it to the machine.
If the coffee grounds container is full,
any function of making beverage
will be out of service.
Take the coffee grounds container
out, empty the coffee grounds
container and reinstall it.
If water in the water tank is used up,
any function of making beverage
will be out of service.
Fill the water tank with water.
If coffee beans in the bean container are
used up, function of making coffee
will be out of service.
Add beans into bean container,
and press any button to release.
There is not enough coffee powder
in the powder container.
Next time when making coffee with
coffee powder, please put a full
spoon of powder.
The drip tray is not installed correctly;
any function is out of service.
Install the drip tray correctly.
The water in the pipe inside the machine
is not enough; any function is out of
service.
Press any button to release to run
the water self-check system.
Temperature of the machine is too high,
the machine cannot be used.
Power off the main power, and use
it 1 hour later.
Temperature of the machine is too low,
the machine cannot be used.
Increase environmental temperature
to above 10°C.
1. Line clossing; 2. Using dark roasted
coffee beans or over fine coffee powder;
3. The filter of the brewer is clogged.
1. Press any button to release to run
the self-check system; 2. Adjust grinder
wheel to rougher; 3. Start brewer cleaning
procedure (refer to P16).
Internal parts stucked. Press any button to run the self-test
system.
8. DISPLAY INFORMATION
•
This chapter will instruct you the information shows on the screen
and the solutions.
To Next Page
Loading...
