3
EN
Dear Customer,
Thank you for purchasing this Hendi appliance. Please read this manual carefully before connecting the
appliance in order to prevent damage due to incorrect use. Read the safety regulations in particular very
carefully.
1. TECHNICAL SERVICE
A technical check-up once or twice a year helps pro-
long the life of the appliance and guarantees better
operation. Make sure that assistance is carried out
solely and exclusively by qualifi ed personnel. For
any spare parts orders or for any information about
the appliance, always mention the serial number
and model (data indicated on the “technical data”
plate at the rear of the oven).
2. GENERAL WARNINGS
• If, on receipt of the goods, the packaging is dam-
aged, write the following on the delivery note:
“I REVERSE THE RIGHT TO CONTROL THE
GOODS”,
specify the damage and get the driver
to sign in acceptance; send a claim in writing to
the seller within 4 calendar days from the date
of receipt. No claim shall be accepted after such
period.
• The warehouse inside temperature must not be
lower than -9°C; otherwise, the thermostat (reg-
ulation and safety thermostat) control devices of
the machine will be damaged. Failure to observe
this prohibition invalidates any responsibility of
the manufacturer of the machine.
• The appliance is intended for professional use
and must be utilised by qualifi ed personnel
trained to use it.
• Any modifi cation which may be necessary on the
electrical system to enable installation of the ap-
pliance, must be carried out solely by competent
personnel.
• It is dangerous to modify or attempt to modify the
characteristics of this appliance.
• Never clean the appliance with direct water jets,
because, if any water enters, it could limit the
machine’s safety.
• Before doing any maintenance or cleaning jobs,
disconnect the appliance from the electrical
mains and allow it to cool.
• When the tilting door is wide open, do not put an-
ything
on the surface, because the door hinges
could be irreparably damaged.
• Do not attempt to carry out the periodic controls
or any repairs by yourself. Contact the nearest
Service Centre and use only original spare parts.
N.B.: Improper or incorrect use and failure to ob-
serve the installation instructions shall release
the manufacture from all responsibility. In this
connection, the directives in the “POSITIONING”
paragraph must be strictly observed.
To Next Page
Loading...