without the fuel retainer in position.
using the following procedure:
rear face upwards.
both clips, and ixings.
Wear suitable gloves for this procedure. Take note of the position and
joint of the rope gasket.
rope as you go, start at the bottom of the window, centrally. Push the
adhesive side of the rope into the grove on the rear of the door cast-
ing gradually work your way round until the ends of the rope meet.
-
ket.
tighten the ixings as damage may occur to the glass.
over the hinge pins and slot into place.
ensure you have it installed correctly as shown in the diagram.
The longer section of the bale plate needs to be at the top of the
stove and sits on the metal lip.
The shorter end of the bale plate sits behind the metal plate at the
back of the stove as shown.
Maintenance
www.henleystoves.com | 11
Top part of bae
Rear part of bae
Remove clips and xings
Be careful when removing
broken glass