Door handle
Please ensure you use a protective glove when opening the the door on this applicance as it may become hot
Properly installed, operated and maintained, this appliance will not emit fumes into the room. Occasional fumes from de-ashing
and
refuelling may occur. Persistent fume emission is potentially dangerous and must not be tolerated.
Because of this an electronic carbon monoxide detector conforming to the latest edition of BSEN50291 must be itted in the same
room as the appliance. The existence of an alarm must not be considered a substitute for ensuring regular servicing and mainte-
Wood logs - Burn only seasoned timber with a moisture content
of less than 20%. To ensure this allow cut wood to dry for 12 to 18
months. Poor quality timber causes low combustion eiciency, pro-
and life of the
appliance. DO NOT burn construction timber painted, impregnated /
treated wood, manufactured board products or pallet wood.
Wood length max 200mm, and 100mm in diameter.
Solid fuel - Burn only anthracite or manufactured briquette smokeless fuels listed as suitable for use with closed heating appli-
ances.
DO NOT burn bituminous coal, ‘petro-coke’ or other petroleum based fuels as this will invalidate the product warranty.
We recommend that you have two or three small ires before you operate your stove to its maximum heat output. This is to al-
low the paint to cure in steadily and to give a long service life of the paint inish. During this curing in process you may notice an
leave all doors and windows open.
or
minutes to enhance initial starting and reduce smoke emission – DO NOT leave the stove unattended if the door is left ajar. Allow
the fuel to reach a steady glow and build the ire up gradually by adding a few small sticks or well split logs at a time. Once you
have a good ire bed
established across the grate, further fuel can be added step by step as required. Don’t be tempted to overload the ire bed with fuel
all at once or close down the air controls too much until the ire is really well established for some time. Once the ignition period is
well under way close the primary air and gradually reduce the secondary air wash control opening to establish the burning inten-
sity you require (usually open 25% approx.).
When burning wood, the ire will die down as the fuel is consumed. When the lames disappear and the remainder is breaking
solid wood left this indicates excessive moisture in the wood or insuicient air supply/lue draught.
Note: To eliminate unwanted smoke emission, after loading new logs on to the ire, open the air wash control up fully for 12 min-
utes to boost the ire and get lames issuing from the top of the fuel as soon as possible. When lames are well established, reduce
the air wash to the running setting required. Burning without lames above the fuel will create unnecessary smoke. Do not load fuel
above the tertiary air inlet
holes at the back of the irebox.
producing a high output for a short time and a large log will take longer to burn and produce less output over a given time.
This appliance is approved for intermittent operation on wood (0.75 to 1.5 hour burn cycles) although much longer burn times can
be achieved by fully loading the irebox, getting the fuel burning well and then shutting the air controls down. The ire will then
often need
reviving by irst de-ashing and then using small pieces of wood and plenty of air to get lames issuing from the wood again.
www.henleystoves.com | 9
To Next Page
Loading...