Henley Arklow - Stove Finish (Paint); Warranty Policy; Chimney Fire and Over Firing; Seasonal Use

Warranty
Please note below what is covered in our warranty policy. You need to register your warranty online or via the post in order to
activate the warranty for your stove. The appliance needs to be installed by a HETAS approved engineer and in accordance of



warrant a service call and can be easily done using the instructions in this manual.

Chimney Fire and Over Firing
-


connector or casing starts to glow red, the appliance is being over-ired. This may result in a chimney ire,






NOTE: The Chimney ire may have caused structural damage to the chimney. Do not use the stove again until the stove, chimney
and
connector have been inspected, and any damage parts have been repaired or replaced. This work should only be carried out by a
HETAS
Maintenance


example if the stove is not used during the warmer periods of the year. Also set the air controls half open to keep the appliance
ventilated and stop the build-up of any moisture inside.
Stove Finish (Paint)

not allow water to remain on the surface when cold or rust may occur. The high temperature paint inish should not require atten-
tion for some time, depending on use. The hotter the ire is burned the sooner repainting will be necessary. Aerosol tins of paint are
available for complete refurbishing. Before repainting make sure the stove is out and cold



-
tion is to prevent the discolouration of the surrounding brickwork, wallpaper etc).





12 | www.henleystoves.com