Mobile Rope Measurement MSM 12
Henning GmbH Page 19 2.0 / 3.2009
8.2 Rope adjustment
On principle, take care that the sensors are mounted in that section of the rope in
which the rope exhibits a maximum length without intermediate deflections or traction
sheaves, as the ropes during stoppage cannot or only slightly balance between the
rope sections.
If, due to the elevator design, this is only possible to some extent, several rope ad-
justments one after the other have to be carried out. In this case the elevator must be
moved several times in order to balance the ropes beyond the traction sheave, too.
To Next Page
Loading...