Hercules DJCONTROL INPULSE 200 MK2 - Loop Controls Usage

12
3. Loop controls
LOOP: enables or disables playback of the loop.
½ / X2: divides by two or multiplies by two the size of the
active loop.
− SHIFT + ½ (LOOP IN): enables a loop by choosing
the in point.
− SHIFT + X2 (LOOP OUT): enables a loop by
choosing the out point.
When the loop is active:
− SHIFT + ½: turn the jog wheel to move the start of
the loop. To set this start of the loop, press
SHIFT + ½ again.
− SHIFT + X2: turn the jog wheel to move the end of
the loop. To set this end of the loop, press
SHIFT + X2 again.
To exit the loop, press LOOP.