HermanMiller Caper - Multipurpose Chair Disassembly; Remove Chair Casters

Z
© 2015 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Caper are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b9rtf rev A.
2
Y
Caper
®
Disassembly for Recycling Instructions
Multipurpose Chair Disassembly
Power driver Safety Glasses Socket Rubber
Mallet
T-40 Torx
Driver
Flat Screw Driver Hammer Nose Plier
Multipurpose Chair Disassembly:
Tool Required:
1. Invert chair on padded
corner of table top.
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling codes. Use these codes to
identify material type for recycling. Non marked components should be treated as mixed plastic.
Ferrous metals can be identied using a small magnet for recycling. Non-ferrous metals should be
separated and recycled separately.
2. Hold base and pull hard
to remove caster from base.