HermanMiller Vantum - Step 12: Tilt Control Removal from Cylinder; Step 13: Base Separation from Cylinder; Step 14: Base Slide-off; Step 15: Caster Removal

HermanMiller Assembly Instructions1BVRRX rev A4
Step 12:
. Remove the old tilt control from cylinder.
Step 13:
. Place nylon cap over the end of cylinder.
. Strike using a mallet on nylon cap to release the base from cylinder.
Step 14:
. Slide base o cylinder.
Step 15:
. Pull out and remove all the casters.
Disassembly for Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling codes. Use these codes to identify
material type for recycling. Non marked components should be treated as mixed plastic. Ferrous metals
can be identied using a small magnet for recycling. Non-ferrous metals should be separated and
recycled separately. To disassemble product, reverse the above installation steps.