HERO GLAMOUR - Integrated Braking System (IBS)

23
PARKING
After stopping the vehicle, shift the
transmission to neutral, turn the fuel valve
CAUTION
!!
•
While parking on side stand engage the first
gear.
•
Park the vehicle on firm level ground to
prevent overturning.
(1) Tool kit (2) First aid kit
2
TOOL KIT/FIRST AID KIT
•
No. 3 cross point screw driver
The tool kit (1) is located below the seat in the rear. For some emergency repairs, minor adjustments and parts replacement can be performed with the tools contained in the kit.
•
Tool bag -1 No.
•
+, - No. 2 driver-1 No.
Kit consists of following tool:
•
Wrench sparking plug -1 No.
•
Spanner 14x17-1 No.
•
Pin spanner-1 No.
For Integrated braking system (IBS)
To stop the vehicle, press the rear brake pedal
for the application of front and rear brakes
simultaneously. However, for more effective
braking, it is advised to apply front and rear
brake simultaneously, keeping the throttle in
closed position.
WARNING
!!
•
When riding in wet or rainy conditions, or on
loose surfaces, apply front brake carefully
after applying rear brake to avoid wheel slip.
•
Extreme braking may cause wheel locking
and reduce control over the vehicle.
•
When riding in wet or rainy conditions, or on
loose surfaces the ability to stop the vehicle
reduces.
•
All your actions should be smooth under these
conditions. Sudden acceleration, braking or
turning may cause loss of control. For your
safety, exercise extreme caution when
braking, accelerating or turning.
•
When descending a long steep slope use
engine braking (power) by changing to lower
gears, with intermittent use of both brakes.
Continuous brake application can overheat
the brakes and reduce their effectiveness.
•
Wherever possible, reduce speed or apply
brake before entering a turn, closing the
throttle or braking in mid turn may cause
wheel slip. Wheel slip will reduce control
over the vehicle.
“OFF”, turn the ignition switch “OFF”, park
the vehicle on main stand, lock the steering
and remove the key.
1
TOOL KIT/FIRST AID KIT
•
+, - No. 2 driver-1 No.
•
Tool bag -1 No.
Kit consists of following tool:
•
Wrench sparking plug -1 No.
•
Pin spanner-1 No.
•
No. 3 cross point screw driver-1 No.
The tool kit (1) is located below the seat in the
rear. For some emergency repairs, minor
adjustments and parts replacement can be
performed with the tools contained in the kit.
•
Spanner 14x17-1 No.