HETRONIC BMS-2 VC - Introduction; Your Manuals; Production and System Numbers; Replacement Parts

2
INTRODUCTION
Thank you for purchasing the Hetronic radio remote
control system. Hetronic radio remote controls
provide outstanding remote control value, quality,
performance and safety.
YOUR MANUALS
Before operation of your machine and radio remote
control system, read and understand the manuals
for all of your system components.
PRODUCTION AND SYSTEM NUMBERS
Before contacting your dealer or Hetronic about
service, repair or replacement parts, note the
equipment Production and System numbers. These
numbers are located on the label affixed to the unit.
REPLACEMENT PARTS
Use only Hetronic replacement parts. Use of other
replacement parts may adversely affect the
performance, durability, and safety of this system
and may void the warranty.
Hetronic disclaims liability for any claims or
damages, whether warranty, property damage,
personal injury or death arising out of the use of
unauthorized replacement parts.
BEFORE OPERATING YOUR SYSTEM
Confirm that installation of all your system
components has been properly completed.
ALWAYS confirm that the machine and radio
remote control Stop functions work properly.
Understand all Safety Precautions provided in the
manuals and review control functions and operation
of the machine and this radio remote control
system.
Confirm that surge suppressors are used when the
receiver is controlling magnetic contactors.
When not in use, turn the transmitter off and store in
a safe place to prevent unauthorized use.
If the machine does not respond properly,
immediately stop operation. Turn off the transmitter
and report the condition to your supervisor.
Turn off the transmitter and remove the key (if so
equipped) before any maintenance work is done.
Always have fresh batteries on hand or an optional
rechargeable battery pack in the battery charger to
ensure the availability of a fully charged battery.
Installation, setup and service must be performed by
authorized and qualified personnel only.
Figure 1: Unit Label Areas and Meanings
Type: Channel:
Production-No.:
System-No.:
www.hetronic.com
1
2
3
4
5
1. Specific approvals, such
as BTZ, FCC, CE, etc.
2. Type of transmitter or receiver.
3. Frequency and RF unit.
4. Eleven-digit Production Number.
Unit Label Areas and Meanings
00000000000
00000000000
5. Eleven-digit System Number.