4. Inflate the spa tub by pressing the “bubble” button.
When the spa is properly inflated, press the “bubble” button to shut off the bubbles..
Attention 1: Do not over inflate.
Attention 2: If you want inflation when the spa has filled water, you must put on the Jets 2-3minutes by pressing the
“bubble” button first, and then operate according to step 2-5 above.
Attention 3: Make sure the bottom spray pipe is flat before you use bubble function, the air bubble cannot come out from
the bottom pipe if the pipe stuck together.
5. Remove the inflation hose and screw the valve tight.
6. Remove the inflation hose from the air outlet and screw the nut tight.
7. Screw the filter cartridge onto the water inlet on the spa wall by turning it clockwise.
Attention : To prevent the small parts entering the control box caused by blocking. Please always install the filter
cartridge when using spa
Page 8/26 17.12.20
To Next Page
Loading...