5. REPAIR AND STORAGE
5.1. Spa repair
In the case of small cracks and other damage, you can use the repair patch supplied or a corresponding repair kit from a specialist dealer. Carefully
dry the damaged area and the area around it. Apply suitable adhesive from a specialist retailer to the repair patch, then press the patch onto the dam-
aged area. Smooth the surface, remove any air bubbles. In this way, small, almost invisible repairs can usually be carried out with little effort.
5.2. Spa storage
Drain off the water inside the water tank completely (please see also Point 4. MAINTAINING, 4.3. Drainage) and wipe off droplets of water on the
walls. After that, layaside the SPA for 24 hours, exhaust the air and fold. Make sure all water is drained from the spa and control box. This is essential
to extend the life of the spa. We recommend the use of a wet/dry vacuum to blow out or suck up water from the spa pipes and pump lines. Remove
the filter cartridge.
Exhaust the air completly and fold. If it is Winter or low temperatures, please fold the SPA indoors. Because outside temperature in Winter or other
Seasons can be very low and materials may become hard. In that case, folding the materials may result in breakage.
Put the SPA inside the packing case after folding it well and then put the case in a dry and not too cold or hot area, it should be a place which is not
for children and avoid direct sunlight.
Note: Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures. Freezing can severely damage the spa. Improper
winterization of your spa may void your warranty!
Page 17/26 17.12.20
To Next Page
Loading...