TEMPERATURE Key
Key for setting temperature. Press this key and the numbers on the
display screen will start flashing, and the keys for increasing or decreasing temperatures can be pressed
to set the temperature. When settings are finished, press the TEMPERATURE Key again to confirm . De
fault temperature is 40°C, and temperature can be set in the range of 20-42°C.
3.3. Body of spa:
1. Water filling of water tank body:
water should be filled to a position 20mm higher than the water line. If lower, heating may not be realized. If higher, water may spill over the
tank in use..
2. Maintenance of water in the water tank body:
2.1 Water in the water tank body should be filtered at fixed time regularly. It is not suggested to filter the water at all times
2.2 Water in the water tank body should be treated with chemical agents periodically. However, chemical
agents with calcium ions must not be used. If chemical agents with calcium ions are used for water treatment,
there will be very likely to form scales on the walls of water tank and inner heating pipes.
Water scales will directly damage the inner electrical components inside the control cabinet and further affect the
service life of control cabinet. Please consult your local pool supply retailer.
2.3 If the filtration system has worked for 168 hours, the system will emit a warning tone to remind the user
to clean or replace the filter element.
3. Conservation of SPA:
please see 5.5 REPAIR AND STORAGE.
Page 12/26 17.12.20
To Next Page
Loading...