4. MAINTAINING
4.1. Maintaining water
1. Clean your filter cartridge at least once a time after it worked continuously for 72- 120 hours. The filter cartridge should be replaced at least
once a month depending on use. Please see → C) Body of spa:, 2. Maintenance of water in the water tank body, Point t 2.1 and 2.3
2. Change water every few days or use appropriate pool chemicals. All spas require the use of pool chemicals. Please consult your local pool
supply retailer for more information about chemical maintenance. Pay close attention to the chemical manufacturer’s instructions. Spa damage
resulting from misuse of chemicals and mismanagement of spa water is not covered by the warranty
a) Water balance; we recommend maintain your water PH between 7.2 and 7.8, total alkalinity between 80 and 120ppm and free chlorine
between 3 to 5ppm. Purchase a test kit to test your water chemistry before each use of the spa, no less than once per week. Low PH will
damage to the spa and pump. Damaged resulting from chemical imbalance is not covered by the warranty.
b) Water sanitation is the responsibility of the spa owner, achieved through the regular and periodic (daily, if necessary) addition of an appro-
ved sanitizer. The sanitizer will chemically control bacteria and viruses present in the fill water or introduced during use of the spa.
4.2. Cleaning the filter cartridge
1. Make sure to unplug the power pack from the electrical receptacle before the following actions.
2. Unscrew the filter cartridge by turning counterclockwise.
3. Remove the filter cartridge cover.
Page 14/26 17.12.20
To Next Page
Loading...