Hexagon ROMER Absolute Arm - Introduction

ROMER Absolute Arm presentation
ROMER ABSOLUTE ARM Manual V2.3.1 (29/05/2012) 3
A
INTRODUCTION
Dear customer, thank you for purchasing a ROMER HEXAGON METROLOGY product. Before
starting any operation with your new ROMER® 3D measuring arm, please read these
instructions.
This guide describes best practices for installing, configuring, and using your measuring arm.
For any other device or option not described in this manual please refer to other Romer
manuals (e.g. RDS Data Collector, RDS Service) available on the Romer / DVD.
For further information, please contact your local Hexagon Metrology agent.
TRADEMARK NOTE
Romer® is a registered trademark of HEXAGON AB in the United States and selected other
countries.
ROMER ABSOLUTE ARM™ is a trademark of HEXAGON AB.
IMPORTANT NOTE
All information contained in this document is subject to be modified without any notification and
does not represent any engagement from HEXAGON AB. The software described in this
manual is furnished under licence agreement and must be used only in conformity with the
terms of this licence. No part of this manual may be reproduced or transmitted under any form
or by any way, electronic or mechanical, including photocopy or recording, for any purpose
without Hexagon AB formal authorisation.
© ROMER
DISCLAIMER NOTE
All non-authorised modification, repair or bad use of the ROMER system will automatically void
the original manufacturer’s guaranty. The manufacturer is not responsible for damages to the
software or hardware caused by unauthorised handling, or use, of this material. For information
regarding the warranty, repair, technical assistance, latest updates and current information
prices, please contact ROMER or your local Hexagon Metrology agent.
PATENT NOTICE
Products described in this manual may be covered by one or more of the following U.S. patents
5,829,148; 6,598,306; 7,003,892; 7,568,293; 7,779,548; 7,908,757; D643,319 and other U.S.
and foreign patents pending.