Hexagon ROMER Absolute Arm - TroubleShoot the Arm; No Connection to the Arm; Non-Contact Probes

TroubleShoot the arm
ROMER ABSOLUTE ARM Manual V2.3.1 (29/05/2012) 91
I
TROUBLESHOOT THE ARM
I.
No connection to the arm
Is the LED on the arm, switched on?
Check power is on and all cables connected
correctly
Is the USB cable between the arm and
computer in good state?
Use correct cable
Is the USB cable correctly plugged in?
LED is Off
Are the cables correctly plugged in?
Is the arm button switched on?
Non-contact probes
The points are not taken correctly
Check that the environment light doesn’t emit
disturbing infra-red parasites.
If the arm stil has problems:
Contact a regional agent with the following information :
- The following page filled out
- RDS.log file