16
2. Graphic
Here, the measurement points are graphically visualized as grid humidity graphics.
Press repeatedly any key (except the <ON/OFF> or <ESCAPE> button) and the
statistical parameters of the measuring array are displayed in the bottom of the screen.
The <ESCAPE> button returns to the menu item Show measurement array.
The statistic parameters are displayed only when the "Grid" is enabled.
The measuring array must have at least two columns and two rows to be displayed as a
graphic. The graphical visualization automatically adjusts to the size of the
measurement array. If the number of measuring points is greater than the number of
pixels of the display, a graphical visualization is only possible with the software
MOISTANALYZE.
3. Statistics
Important statistical values of the measuring field are shown here (average, standard
deviation, minimum, maximum).
If there are several equal minima or maxima in the measurement field, the location
information for the first found location applies.
The statistical values are also displayed in the graphic menu on the bottom of the
screen. (Menu item Graphic). To show the single statistical values press repeatedly
any key (except the <ESCAPE> button). To quit the graphic menu press the
<ESCAPE> button.
4. Set indicating range
To display the grid humidity graphics or the moisture distribution with the „false colour“
profile you can define the upper and the lower border of every layer. These borders will
be saved automatically. They will be available after restart and in the Software
MOISTANALYZE
• The <Auto> mode define the borders automatically by searching for the highest
and the lowest value of the measuring field.
• The <From calibration curve> mode define the borders automatically by taking
the given values of the calibration curve. This mode is the default.
• In the <Manually> mode you can define the borders manually.
To Next Page
Loading...