Index
A.
Abbreviation
Adjusting the CDI unit air gap
Adjusting the start-in-gear protection
cable
Adjusting the throttle cable and
throttle link
Adjusting the throttle link rod
and throttle cable
Adjusting the valve clearance
After test run
Assembling the bottom cowling
Assembling the carburetor
Assembling the clamp bracket
Assembling the cylinder block
Assembling the cylinder head
Assembling the extension
(L-transom model)
Assembling the fuel pump
Assembling the lower case
Assembling the manual starter
Assembling the propeller shaft assembly
Assembling the propeller shaft housing
assembly
Assembling the tiller handle
Automatic decompressor
B.
Battery requirement
Blowby gas reburning system
Blowby hose, oil return hose, and cooling
water hose
Bottom cowling
Brack
et unit
Break-in
Built-in primer pump
C.
Carburetor
CDI unit
Changing the engine oil
Changing the gear oil
Charging system
Charging unit and component
Checking the anode
Checking the battery
Checking the camshaft
Checking the carburetor
Checking the CDI unit air gap
Checking the compression pressure
Checking the connecting rod oil
clearance
Checking the connecting rod small end inside
diameter and big end inside diameter
Checking the cooling water passage
Checking the cooling water pilot hole3
Checking the crankcase
Checking the crankshaft
Checking the cylinder block
Checking the cylinder bore
Checking the cylinder head
Checking the diaphragm and valve
Checking the dog clutch
Checking the drive shaft
Checking the electrical componenW
Checking the engine idle speed
Checking the engine oil level
Checking the engine shut-off VZLWFK
Checking the forward gear
Checking the fuel joint
Checking the fuel joint and fuel hoses (fuel joint
to carburetor)
Checking the fuel pump
Checking the fuel strainer
Checking the fuel strainer (tank side)
Checking the fuel system
Checking the fuel tank
Checking the gear oil level
Checking the gear shift and throttle
operation
Checking the ignition spark
Checking the ignition timingChecking
the lighting coil
Checking the lower case
Checking the lower unit anode
Checking the lower unit for air leakage
Checking the manual starteUChecking
the oil seal housingChecking the oil
strainer
Checking the outboard motor mounting
height
Checking the pinion
Checking the piston diameter
Checking the piston pin boss inside
diameter
Checking the piston pin diameter
Checking the piston ring
Checking the piston ring end gap
Checking the piston ring groove
Checking the piston ring side clearance
Checking the primer pump
Checking the propeller
194
To Next Page
Loading...
