Hidea HDF6 - Page 195

Index
Checking the propeller shaft
Checking the propeller shaft housing
Checking the push rod
Checking the Rectifier Regulator
Checking the reverse gear
Checking the rocker arm
Checking the rotor assembly
Checking the shift rod
Checking the spark plug
Checking the spark plug cap
Checking the spiral spring
Checking the steering system
Checking the thermostat
Checking the thermostat cover anode
Checking the throttle cableChecking
the tilt system
Checking the top cowling
Checking the upper case
Checking the valve
Checking the valve clearance
Checking the valve guide
Checking the valve lifter
Checking the valve seat
Checking the valve spring
Checking the water pump
Clamp bracket
Cooling flow diagram
Crankcase
Crankcase assembly
Cylinder block
Cylinder head
Cylinder head assembly
D.
Dimension
Dimension and weight
Disassembling the bottom cowling
Disassembling the carburetor
Disassembling the clamp bracket
Disassembling the cylinder block
Disassembling the cylinder head
Disassembling the extension (L-transom
model)
Disassembling the fuel pump
Disassembling the lower case
Disassembling the manual starter
Disassembling the propeller shaft
assembly
Disassembling the propeller shaft housing
assembly
Disassembling the tiller handle
Disassembly and assembly
Drive shaft and lower case
E.
Electric shock
Electrical component and wiring harness
routing
Electrical technical data
Engine control system
Exterior +')
F.
Flywheel magnet
Fuel and oil requirement
Fuel hose
Fuel pump
Fuel system
Fuel system technical data
Fuel tank
G.
General feature
General periodic maintenance
General tightening torque
H.
Handling of gasoline
Handling of sealant
High speed operation
Hose routing
Hot part
How to use this manual
I.
Idle and low speed operation
Ignition cut-off control
Ignition timing control
Ignition timing control system
Ignition unit and component
Installing the battery
Installing the carburetor
Installing the charging system
Installing the crankcase
Installing the cylinder head
Installing the drive shaft
Installing the flywheel magnet
Installing the fuel pump
Installing the fuel tank
Installing the lower unit
(L-transom model)
195