Need help?Do you have a question about the Hifonics BXi 8000D and is the answer not in the manual?
General| Peak Power | 16000 Watts |
|---|---|
| Signal to Noise Ratio | > 100 dB |
| THD at Rated Power | < 0.1% |
| Damping Factor | > 200 |
| Minimum Impedance | 1 Ohm |
| Subsonic Filter | 10 Hz - 50 Hz |
| Low Pass Filter | 35 Hz - 250 Hz |
| Phase Shift | 0 - 180 degrees |
| THD | < 0.1% |
| RMS Power at 1 Ohm | 8000 Watts |
| RMS Power at 4 Ohms | 2000 Watts |
| Frequency Response | 10Hz - 350Hz |
| Bass Boost | 0dB - 18dB |
| Operating Voltage | 12V - 16V |
| RMS Power at 2 Ohms | 4000W |
| Input Sensitivity | 0.2V - 8V |
Describes physical mounting procedures and drilling for the amplifier.
Details the wiring and connection of power, ground, and remote signals to the amplifier.
Describes RCA and Balanced inputs, and adjusting input sensitivity for optimal audio signal.
Explains phase adjustment, sub boost, frequency range, Q-factor, and subsonic filter settings.
Details the mode switch (Master/Slave) and the low pass filter for frequency range adjustment.
Covers power/protect LEDs, remote port, and slave in/out connections for multi-amplifier setups.
To Next Page