Chapter
3
Parameter setting
Chapter 3 explains the individual servo parameter setting according to the usage. The
parameter setting can be executed with the internal mount loader and digital loader, and refer to
Chapter 5 for details on how to use the internal mount load and digital loader. The parameter
NO. with the symbol (＊) marked indicates that the value can only be corrected when the
SVONEN input contact point is “OFF”.
3.1 Status display parameter .....................................................................3-1
3.2 Motor and operating device setting......................................................3-5
3.3 General control parameter setting .......................................................3-8
3.4 Speed control pararmeter setting.......................................................3-15
3.5 Input contact point digital speed and torque setting...........................3-20
3.6 Position control parameter setting .....................................................3-21
3.7 Torque control parameter setting .......................................................3-23
3.8 Input contact point function setting ....................................................3-25
3.9 Output contact point function setting .................................................3-30
3.10 Analog monitor function setting........................................................3-35
3.11 Jog operation parameter setting ......................................................3-36
3.12 Alarm display setting........................................................................3-38
To Next Page
Loading...