Section 7 - Troubleshooting
Page 7-2
Symptom Problem Solution
Uncut Material Excessive Ground Speed Reduce Ground Speed
RPM to Low Use Full PTO Speed and
Check for Correct Gearbox
Ratio
Drive not functioning (blades
do not turn when PTO is
running)
Check drive shaft
connection. Check
gearboxes
Improper Blade for Direction
of Cut
Mower Not Setup for the
Primary Cutting Conditions
Worn or broken blades Replace Blades with
Highline parts
Excessive clutch slippage Check clutch and repair as
needed
Poor Shredding of Material Excessive Ground Speed Reduce Ground Speed to
Circulate Material Longer
Cutting to High Lower Cutting Height
Build Up of Material under
the Mower Deck
Clean Underside of Mower
Material Heavy and Lush Decrease Ground Speed
To Next Page
Loading...