Section 3 - Mower Preparation
Page 3-4
9. Lower the Wings on Level Ground.
10. Level the Mower Center Section Deck
Front to Back
Note: Do this procedure on level ground.
- Raise the mower to full height by
extending the height cylinders.
Hold the lever for a few seconds to
ensure the phasing cylinders are
synchronized.
- Lower the mower to the preferred
cutting height.
- Measure the left side from the
center of the front wing pivot to the
ground. Verify this measurement at
the left back wing pivot to the
ground.
- Compare this height to the right
front and the right back at the
center of the wing pivots to the
ground.
Lower the Wings
107087
Height from Front Wing Pivot to Ground
107027
Height from Back Wing Pivot to Ground
107028
To Next Page
Loading...