Table of Contents
1 32
Step 3 – Power ON your system
• Connect all peripherals and computers to the KM prior to powering
it up. Power ON the KM by plugging it to the AC wall outlet. By
default, after product power-up, the active channel will be computer
#1, indicated by the applicable front panel push button LED lit.
Note: Power ON self-test: As the product powers-up it performs a self-test
procedure. In case of self- test failure for any reason, including jammed buttons,
the product will be Inoperable. Self-test failure will be indicated by abnormal
LED behavior – for further information please refer to the KM setup guide.
To Next Page
Loading...
Need help?
General
