Hikmicro E03 - Setting Temperature Alarm; Upgrade Device

English
11

Emissivity: Enable Custom, and select Emissivity to set the emissivity of the target as the effectiveness in
emitting energy as thermal radiation or choose the preset emissivity.

Distance: The distance between the target and the device.
Tap to save and exit.
Optional: Go to Settings > Display Settings > Unit to set the temperature unit and distance unit.
Setting Temperature Alarm
When the temperature of targets triggers the set alarm rule, the device will perform configured actions.
Tap and go to Local Settings > Temp Measurement Settings > Alarm Settings.
Enable Temperature Alarm and set the alarm parameters.

Alarm Threshold: The threshold temperature for triggering alarms.

Alarm Linkage: Flashing Alarm. The flash light flashes when target temperature exceeds the alarm
threshold.
4. Tap to save and exit.
CHAPTER 7 MAINTAINING CAMERA
Upgrade Device
1. Connect the device to your PC via the supplied USB
cable, and select USB Drive as the USB mode in the
prompt on the device.
2. Unzip the upgrade file and copy it to the root
directory of the device.
3. Disconnect the device from your PC.
4. Reboot the device and then it will upgrade
automatically. The upgrading process will be