Thermal Image Scope User Manual
vii
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
● Use of the product must be in strict compliance with the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging while transporting it.
● Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need
to return the device to the factory with the original wrapper. Transportation without the
original wrapper may result in damage on the device and the company shall not take any
responsibilities.
● DO NOT drop the product or subject it to physical shock. Keep the device away from magnetic
interference.
Power Supply
● The input voltage for the device should meet the Limited Power Source (5 VDC, 2 A) according
to the IEC61010-1 standard. Please refer to technical specifications for detailed information.
● Use the power adapter provided by qualified manufacturer. Refer to the product specification
for detailed power requirements.
● Make sure the plug is properly connected to the power socket.
● DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
caused by overload.
Battery
● Improper use or replacement of the battery may result in explosion hazard. Replace with the
same or equivalent type only. The battery type is 18650 with the protection board, and the
battery size should be within 19 mm × 70 mm. The rated voltage and capacity are 3.6 VDC/3.35
Ah (12.06 Wh). Dispose of used batteries in conformance with the instructions provided by the
battery manufacturer.
● For long-term storage of the battery, make sure it is fully charged every half year to ensure the
battery quality. Otherwise, damage may occur.
● Do not charge other battery types with the supplied charger. Confirm there is no flammable
material within 2 m of the charger during charging.
● DO NOT place the battery near heating or fire source. Avoid direct sunlight.
● DO NOT swallow the battery to avoid chemical burns.
● DO NOT place the battery in the reach of children.
● The battery cannot be charged with external power source directly.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center.
To Next Page
Loading...
Need help?
General
