Thermal Image Scope User Manual
6
Figure 2-3 Install Batteries
3. Rotate the knob clockwise to tighten it.
Take the battery away if the device is not used for a long time.
2.2.1 Select Battery Type
You can change the battery type according to your need. Select the correct battery voltage in the
device menu.
Steps
1. In the view mode, hold to show the menu.
2. Select , and press to switch the voltage.
2.3 Secure Device
Before You Start
● Turn off the device first.
● Use the Non-dust cloth to clean the device base and the gun's base.
Steps
1. Install the device to the gun base as arrow 1.
2. Insert the screws, and tighten them.
To Next Page
Loading...
