HikRobot SC5000 Series - Page 11

SC5000 Series Smart Camera Quick Start Guide
3
Table 2-1 Component Description
No.
Name
Description
1
Lens Cap
It can be replaced with other lens cap.
2
Screw Hole
It is used to fix the device to the installation position. It is recommended
to use supplied M4 screws.
3
Light Source
It refers to LED lamps providing light.
Note
● The default color of LED lamps is white. Red, blue and NIR are optional.
● The type II device does not have own light source, and you can use an
external light source instead.
4
Gigabit Ethernet
Interface
It refers to gigabit Ethernet interface for transmitting data. The interface
is designed with screw threads to tighten connection between the device
and cable, and thus avoiding influence caused by vibration.
5
12-Pin M12
Interface
It provides power, input/output, and serial port signal. The interface is
designed with screw threads to tighten connection between the device
and cable, and thus avoiding influence caused by vibration.
6
PWR Indicator
It is the power indicator. The indicator is solid blue when the device
operates normally.
7
LNK Indicator
It is network connection indicator. The indicator is solid green when the
network transmission is normal.
8
ACT Indicator
It is network transmission indicator. The indicator is flashing yellow when
the network transmission is normal. The flashing speed is related with
data transmission speed.
9
U1/U2 Indicator
The device has 2 user indicators, U1 and U2. They are used to indicate
whether some functions of the device are normal or not.