SC5000 Series Smart Camera Quick Start Guide
10
Note
It is recommended to use the static IP address to reduce time for searching the device.
3. Set NIC property.
1) Go to NIC settings page: Control Panel → Hardware and Sound → Device Manager →
Network Adapter.
2) Select corresponding network interface card, and click Advanced.
3) Set Jumbo Packet value to 9014 Bytes.
5.2 Install Client Software
SCMVS is a client software for device configuration and remote operations.
Note
●
Check the Windows version. The client software is compatible with 32/64-bit Windows 7/10.
●
You can get the client software installation package from https://en.hikrobotics.com/.
●
The graphic user interface may differ by different versions of client software you use.
Steps
1. Double click the installation package to install the client software.
2. Select the language.
3. Read and check Terms of the License Agreement.
4. Click Start Setup.
Figure 5-2 Installation Interface
5. Select installation directory and click Next.
6. Finish the installation according to the interface prompts.
To Next Page
Loading...
