HIKVISION 7604NI-K1B User Manual

Network Video Recorder User Manual
303
If not, please contact the engineer from Hikvision to do the further process.
 No record file found in the NVR local HDD, and prompt “No record file found”.
Possible Reasons:
− The time setting of system is incorrect.
− The search condition is incorrect.
− The HDD is error or not detected.
Step 1 Verify the system time setting is correct.
Select “Menu > Configuration > General > General”, and verify the “Device Time” is correct.
Step 2 Verify the search condition is correct.
Select “Playback”, and verify the channel and time are correct.
Step 3 Verify the HDD status is normal.
Select “Menu > HDD > General” to view the HDD status, and verify the HDD is detected and
can be read and written normally.
Step 4 Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from Hikvision to do the further process.

HIKVISION 7604NI-K1B Specifications

General

Model	7604NI-K1B
HDMI Output Resolution	4K (3840 × 2160)
VGA Output Resolution	1920 × 1080
Decoding Format	H.265+/H.265/H.264+/H.264
Video Compression	H.265+/H.265/H.264+/H.264
Max Incoming Bandwidth	40 Mbps
HDD Bays	1
Storage Interface	SATA
Max HDD Capacity	6TB
Max Storage Capacity	6TB
USB Interface	2 × USB 2.0
Power Supply	12 VDC, 1.5 A
Consumption	≤ 10 W (without HDD)
Operating Humidity	10% to 90%
Synchronous Playback	4-ch
Type	NVR
Channel Capacity	4
Network Protocol	TCP/IP, DHCP, DNS, DDNS, NTP, UPnP
Network Interface	1 × RJ-45 10/100/1000 Mbps
Working Temperature	-10°C to +55°C (14°F to 131°F)
Operating Temperature	-10°C to +55°C (14°F to 131°F)
Video Output	1 × VGA, 1 × HDMI