HIKVISION AX DS-PWA32-HG - Add Control Panel to the Mobile Client

Note
You need to remove the rear panel of the device and the AP/STA switch is on the back of the
device.
8. Select a stable Wi-Fi for the device to connect and tap Next.
Note
Make sure the device and the mobile phone are connect to the same Wi-Fi.
9. Follow the instrucons. Create the device password and tap Acve.
Note
We highly recommend you to create a strong password of your own choosing (using a minimum
of 8 characters, including at least three kinds of following categories: upper case leers, lower
case leers, numbers, and special characters) in order to increase the security of your product.
And we recommend you reset your password regularly, especially in the high security system,
reseng the password monthly or weekly can beer protect your product.
10. Follow the instrucons on the Turn on Hotspot page and change the control panel to the STA
mode. Tap
Conrm.
Note
You need to remove the rear panel of the device and the AP/STA switch is on the back of the
device.
11. Aer the connecon is nished, enter the device alias and tap Save.
12.
Oponal: You can delete the device.
1)On the device list page, tap the security control panel and then log in to the device (if
required) to enter the
paron page.
2)Tap → Delete Device to delete the device.
4.4.3 Add Control Panel to the Mobile Client
Add a control panel to the mobile client before other operaons.
Before You Start
• The control panel has been
acvated.
• The control panel has registered to Hik-Connect. For details, see Mobile Client Registraon .
Steps
1. Power on the control panel.
2. Select adding type.
-
Tap → Scan QR Code to enter the Scan QR code page. Scan the QR code on the control
panel.
AX Security Control Panel
60