101
Ask the network carrier and enter the password.
APN
Ask the network carrier to get the APN information.
Data Limit
You can enable the function and set the data threshold every month.
Used Traffic This Month
The used data will be accumulated and displayed in this text box.
Traffic Threshold
If data usage is more than the configured threshold, an alarm will be triggered and uploaded
to the alarm center and mobile client.
Network Connection Test
Click Test to check network connection status.
8. Click Save.
Network Service
HTTP(S)
Click Configuration → Network → Network Service → HTTP(S) to enter the page.
You can set HTTP port here.
NAT
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices
to connect seamlessly and to simplify the implementation of networks in the home and corporate
environments.
Enable the UPnP function, and you don’t need to configure the port mapping for each port, and
the device is connected to the Wide Area Network via the router.
1. Click Configuration → Network → Network Service → NAT to enter the page.
Port Mapping Mode
-Auto: Get the port number automatically.
-Manual: You need to enter external ports.
2. Click Save.
Device Access
If you want to enroll the device to the mobile client for remote configuration, you should set the
mobile client enrollment parameters.
Before You Start
● Connect the device to the network via wired connection, dial-up connection, or Wi-Fi
connection.
To Next Page
Loading...
