49
Alarm Receiving Center (ARC)
You can set the alarm receiving center's parameters and all alarms will be sent to the configured
alarm center.
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Alarm Receiving Center (ARC) to enter the page.
3. Select an ARC and enable it.
Protocol Type
Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, *ADM-CID, CSV-IP, FSK
Module or RDC Module to set uploading mode.
Intruder Verification as a Service
When the control panel uploads the alarm information, it will return the picture and video
address for you to view.
Companies
Select the support company as None, Hungary-Multi Alarm Receiving Company or French
Alarm Receiving Company.
Address Type
Select the Address Type as IP Address and Domain Name. Enter server address/domain name,
port number and account code.
Transmission Mode
Select the Transmission Mode as TCP or UDP. UDP is recommended by the SIA DC-09
standard.
Retry Timeout Period
After the selected time, the system will retry to transmit.
Attempts
Set the number of retry attempts.
Polling Option
Set the polling rate with the range from 10 to 3888000 seconds. The system will report fault if
the time is over the limit. The status of device will be shown as offline.
Periodic Test
After enabling, you can set the time interval, setting how often to send a test event to the
ARC to ensure the connection.
GMT
Enable the Greenwich Mean Time.
To Next Page
Loading...
Need help?
General
