HIKVISION DS-2AE714

IR Speed Dome User Manual
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
5
DOME SETUP
!! SYS PARAM SETUP
CAMERA SETUP
PTZ PARAMETER SET
IR PARAM SETUP
PATROL SETUP
PATTERT SETUP
TIMETASK SETUP
PRIVACY MASK
BACK EXIT
Figure 3-2 Dome Setup
3.2.1 Configuring the System Parameters
Purpose:
You can check and also edit the system information of the software address, baudrate, system time,
etc. on the system information settings menu.
Enter the system information settings menu:
MAIN MENUS > DOME SETUP> SYS PARAM SETUP
SYS PARAM SETUP
!! SOFT ADDR NUM 1
SOFT ADDR OFF
SOFT BAUD RAT 2400
SOFT BAUD OFF
BROADCAST ADDR ON
PELCO CHECKSUM ON
TIME SETUP
BACK EXIT
SYS PARAM SETUP
PAN ZERO SETUP
DISPLAY SETUP
!! BACK EXIT
Figure 3-3 System Information Settings
Note: You can click the left and right direction buttons in the PTZ control panel via the IE browser of
the DVR to enter the next page and return to the previous page of the submenu if more than one
page is available.
Descriptions of system parameter configuration:
 Soft Address Settings
If the SOFT ADDR is set as ON, the soft address is the valid address for connecting to the IR
speed dome. The selectable soft address range is from 1 to 255;
If the SOFT ADDR is set as OFF, the hard address set by the DIP switch is the valid address of the
speed dome (the hard address is set as 0 by default).
Notes:
1. Before you set the soft address of the speed dome, you need to confirm the control range of