The value of gain indicates the amplification degree of the original image signal. You can set the
value from 0 to 15.
Exposure Compensation Function:
You can set the EXPOSURE COMP value from 0 to 14. The value change can affect the exposure
effect, and the default value is 7.
White Balance:
You can set WHITE BALANCE mode as AUTO, INDOOR, OUTDOOR, SELFDEF (self-defined), ATW
(auto-tracking) and HAUTO (half-auto).
Image Flip:
If you turn the IMAGE FLIP function on, the image will be flipped diagonally along its central axis,
shown as the mirror reflection of the image.
Note: The image flip function is only supported by a certain camera model series.
Focus Limit
You can set FOCUS LIMIT as 30CM, 1M or 3M to make sure that the speed dome focuses on the
target; when you set it as 1M (default), the focus limit will automatically change according to
the lens zooming.
Init Lens
You can turn the INIT LENS on to trigger a spontaneous lens initiation to ensure the normal
operation
Noise Reduction:
There are two options for noise reduction: ON or OFF.
HR Mode
Set the HR MODE as ON to adjust the resolution higher. Switch it OFF to disable the function,
which can avoid cross color of the image.
Contrast:
Adjust the image contrast on CONTRAST submenu to 0-7.
Saturation:
Adjust the image saturation on SATURATION submenu to 0-7.
3.2.3 Configuring the PTZ Parameters
You can configure the Park Time, Image Freeze, Dome Speed, etc. according to the steps in this
session. See Figure 3-7. Enter PTZ configuration menu:
MAIN MENUS > DOME SETUP > PTZ PARAMETER SET
To Next Page
Loading...
