User Manual of Network Camera
59
Figure 6-28 Day/Night Scheduled-Switch Configuration Interface
Steps:
1. Click the time line to select the start time and the end time of the switch.
2. Click Common tab to configure the common parameters applicable to the day
mode and night mode.
Note:
The detailed information of each parameter please refers to day/night auto switch
session.
3. Click Day tab to configure the parameters applicable for day mode.
4. Click Night tab to configure the parameters applicable for night mode.
Note:
The settings saved automatically if any parameter is changed.
6.5.2 Configuring OSD Settings
Purpose:
You can customize the camera name and time on the screen.
Steps:
1. Enter the OSD Settings interface:
Configuration > Advanced Configuration > Image > OSD Settings
To Next Page
Loading...
