The camera supports Dead Pixels Compensation
function. It will correct the defective pixels which are not
performed as expected. You can set the Manual DPC to
Manual or OFF, and if you select Manual for it, then you can
enter the parameter interface to configure the parameters
for White Thr (range from 0 to 255), Black Thr (range from
0 to 255), and DPC Level (range from 0 to 255).
Auto DPC
You can set the AUTO DPC to AUTO or OFF, and if you select
Auto for it, then you can set the DPC Level (range from 0 to
50), and DPC RUN from the sub-menu.
OLPF (Optical Low Pass Filter)
OLPF can reduce or eliminate the color rendition effect of
the infrared. The value for it can be set to 850 filter
(IR-PASS) or 650 filter (IR-CUT).
OSD(On Screen Display) COLOR
Blue, Magenta, Cyan, Gray, Black, White, Red, Green are
the selectable color for OSD.
To Next Page
Loading...
Need help?
General
