1. Move the cursor to MOTION DET, and switch it to ON and
press the menu button to enter the submenu.
2. Position the cursor on DETECT SENSE, and switch the menu
button left/right to adjust the sensitivity level.
3. Position the cursor on BLOCK DISP, and switch the menu
button left/right to select ENABLE.
4. Press the menu button to enter the blocking area settings
interface.
5. You can press the menu button once to set a pane as a blocking
area, or press it again to cancel it.
6. Press and hold the menu button for 2 seconds to return to the
previous menu.
7. Select ON to enable BLOCK DISP.
8. Move the cursor to MONITOR AREA and select ON.
9. Return to the MAIN MENU and click SAVE ALL.
10. You can find the BLOCK DISP taking effect after you exit the
main menu.
MONITOR AREA
Steps:
1. Move the cursor to MOTION DET, and select ON and press the
menu button to enter the submenu.
2. Position the cursor on DETECT SENSE, and select the menu
button left/right to adjust the sensitivity level.
3. Position the cursor on MONITOR AREA. Select ON to enable
area motion detection.
To Next Page
Loading...
Need help?
General
