HIKVISION DS-2DE5425IWG-4G - Set One-Touch Patrol; Set Pattern Scan

It is the duraon staying on one patrol point.
Delete the presets in patrol.
Adjust the preset order.
Note
A patrol can be congured with 32 presets at most, and 2 presets at least.
4.
Click OK to nish a patrol seng.
5.
Repeat the steps above to congure mulple patrols.
6.
Operate patrols.
Call the patrol.
Stop patroling.
Delete the patrol.
Note
You can delete all patrols in Conguraon → PTZ → Clear Cong . Check Clear All Patrols, and
click Save.
3.3.1 Set One-Touch Patrol
The device automacally adds presets to one patrol path and starts patrol scan.
Steps
1.
Set two or more presets except special presets. For seng presets, refer to Set Preset .
The device will
automacally add presets to patrol path No.8.
2.
Choose one of the following methods to enable the funcon.
-
Click
.
-
Call patrol path No.8.
-
Select and call preset No.45.
3.4 Set
Paern Scan
The device can move as the recorded paern.
Steps
1.
Click to show the PTZ control panel, and click .
2.
Select one
paern scan path that needs to be set.
3.
Click to start recording paern scan.
4.
Click PTZ control
buons as demands.
Network Speed Dome User Manual
11