HIKVISION DS-2DE5425IWG-4G - WLAN AP (Access Point); Set WLAN AP

4.
Click Dial Plan. See Set Arming Schedule for detailed informaon.
5.
Click Dial Status.
Click Refresh Refresh the dial status.
Click Disconnect Disconnect the 3G/4G wireless network.
When the Dial Status turns to Connected, it means a successful dial.
6.
Access the device via the IP Address of the computer in the network.
-
Input the IP address in the browser to access the device.
-
Add the device in client applicaon. Select IP/Domain, and input IP address and other
parameters to access the device.
9.20 WLAN AP (Access Point)
The device can be used as a wireless access point with the WLAN AP funcon. You can connect
your phone or PC to the device AP, so as to access to the device and congure the parameters via
your phone or PC.
Note
The funcon is only supported by certain device models.
9.20.1 Set WLAN AP
Steps
1.
Go to
Conguraon → Network → Advanced Sengs → WLAN AP .
2.
Select the WLAN AP mode.
On
The funcon is enabled.
Maintenance Mode
The WLAN AP
funcon is automacally turned on for 5 minutes aer the device is cold
booted (by turning the switch on the device to ON), aer which the WLAN AP funcon is
turned o if the device's 4G communicaon is normal, and remains on if the device's 4G
communicaon is abnormal.
O
The funcon is disabled.
3.
Set the related parameters.
SSID
The default SSID of the device is named as "Hik-Serial Number". You can
dene it as needed.
Security Mode
WPA2-personal mode is supported.
Network Speed Dome User Manual
79