HIKVISION DS-2DE5425IWG-4G - Chapter 7 Event and Alarm; 7.1 Basic Event

Chapter 7 Event and Alarm
This part introduces the conguraon of events. The device takes certain response to triggered
alarm. Certain events may not be supported by certain device models.
7.1 Basic Event
7.1.1 Set Moon Detecon
This funcon detects moving objects in the detecon region and trigger linkage acons.
Steps
1.
Go to
Conguraon → Event → Event and Detecon → Moon Detecon .
2.
Check Enable.
3.
Oponal: (Only available in PTZ channel) Check Enable Moon Detecon in PTZ Control, and
the device detects moving targets in PTZ movement.
4.
Oponal: Highlight moving objects in green.
1) Check Enable Dynamic Analysis for Moon.
2) Go to
Conguraon → Local to enable Rules.
5.
Select conguraon mode. Normal mode and expert mode are selectable.
-
For the informaon about normal mode, see Normal Mode .
-
For the
informaon about expert mode, see Expert Mode .
6.
Set the arming schedule. See Set Arming Schedule for details.
7.
Set linkage methods. See
Linkage Method Sengs for details.
8.
Click Save.
Normal Mode
You can set moon detecon parameters according to the device default parameters.
Steps
1.
Select Normal Mode in Conguraon.
2.
Set the
Sensivity of normal mode. The higher the value of sensivity is, the more sensive the
moon detecon is. If the sensivity is set to 0, moon detecon and dynamic analysis do not
take eect.
3.
Set Detecon Target. Human and vehicle are available. If the detecon target is not selected, all
the detected targets will be reported, including the human and vehicle. This funcon allows
alarm triggering by
specied target types (human and vehicle).
Network Speed Dome User Manual
45