HIKVISION DS-2DE5425IWG-4G - Set Alarm Input; Smart Event; General Settings

Note
The funcon is only supported by certain models. The actual funcon varies according to
dierent models.
7.1.5 Set Alarm Input
Alarm signal from the external device triggers the corresponding acons of the current device.
Before You Start
Note
This funcon is only supported by certain models.
Make sure the external alarm device is connected. See Quick Start Guide for cable connecon.
Steps
1.
Go to Conguraon → Event → Event and Detecon → Alarm Input .
2.
Select an Alarm Input NO. and click
to set alarm input.
3.
Select Alarm Type from the dropdown list. Edit the Alarm Name.
4.
Check Enable Alarm Input Handling.
5.
Refer to
Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
6.
Click Copy to... to copy the sengs to other alarm input channels.
7.
Click Save.
7.2 Smart Event
Note
●
For certain device models, you need to enable the smart event funcon on VCA page rst to
show the funcon conguraon page.
●
The funcon varies according to dierent models.
7.2.1 General Sengs
Set the general parameters which are related to the smart applicaons.
Go to VCA → Set Applicaon → General Sengs to set the following parameters.
FTP
For FTP sengs, refer to Set FTP .
Network Speed Dome User Manual
50