HIKVISION DS-2DE5425IWG-4G - Page 77

Steps
1.
Go to Conguraon → Event → Alarm Seng → Audible Alarm Output .
2.
Select Sound Type and set related parameters.
-
Select Prompt and set the alarm
mes you need.
-
Select Warning and its contents. Set the alarm
mes you need.
-
Select Custom Audio. You can select a custom audio le from the drop-down list. If no le is
available, you can click Set → Add to upload an audio le that meets the requirement. Up to
three audio les can be uploaded.
3.
Oponal: Click Test to play the selected audio le on the device.
4.
Set arming schedule for audible alarm. See Set Arming Schedule for details.
5.
Click Save.
Note
The funcon is only supported by certain device models.
Set Alarm Server
Steps
1.
Go to
Conguraon → Event → Alarm Seng → Alarm Server .
2.
Enter Desnaon IP or Host Name, URL, and Port.
3.
Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communicaon.
4.
Click Test to check if the IP or host is available.
5.
Click Save.
Network Speed Dome User Manual
65