Network Speed Dome User Manual
Figure 6-43 RS-485 Settings
2. Set the RS-485 parameters and click to save the settings.
The Baudrate, PTZ Protocol and PTZ Address parameters of the speed dome
should be exactly the same as those of the control device.
Configuring DST (Daylight Saving Time)
Purpose:
If there is the habit of adjusting clocks forward in your country in certain time period
of a year, you can turn this function on. The time will be adjusted automatically when
the Daylight Saving Time (DST) comes.
Steps:
1. Enter the DST interface by Configuration > System > System Settings > DST
2. Check to enable the DST function.
3. Set the date of the DST period.
4. Click to save the settings.
Figure 6-44 DST Settings
To Next Page
Loading...
