© Hikvision
to upgrade the device.
Firmware Directory: You need to find the directory where the firmware locates. The
device can find the firmware in the directory automatically.
3. Click Browse to select the local upgrade file and then click Upgrade to start remote upgrade.
Note:
The upgrading process will take 1 to 10 minutes. Don't disconnect power of the camera
during the process. The camera reboots automatically after upgrading.
Log Searching
Purpose:
The operation, alarm, exception and information of the camera can be stored in log files. You can
also export the log files on your demand.
Before you start:
Configure network storage for the camera or insert a memory card in the camera.
Steps:
1. Enter the Log interface:
Configuration > System > Maintenance > Log
Figure 6-53 Log Searching Interface
2. Set the log search conditions to specify the search, including the Major Type, Minor Type,
Start Time and End Time as shown in Figure 6-53.
3. Click to search log files. The matched log files will be displayed on the Log
interface.
4. To export the log files, click Save Log to save the log files in your computer.
System Service
Steps:
To Next Page
Loading...
Need help?
General
