HIKVISION DS-2DF8C435MHS-DELW User Manual

Note
Face picture is not allowed to change.
5) Click OK.
5.
Create models for each face picture in library.
Modeling process builds up face model for each face picture. Face model is compulsory for face
picture comparison to take eect.
Modeling Select one or more face pictures, and click Modeling.
Batch Modeling Select a face picture library, and click Batch Modeling.
6.
Oponal: Repeat to create more face libraries.
3.5.2 Set Face Picture Comparison
The funcon compares captured pictures with face pictures in the library and outputs comparison
result. Comparison result can trigger certain
acons when arming schedule and linkage method are
set.
Before You Start
You should rst create a face picture library and add face pictures. See Set Face Picture Library .
Steps
1.
Go to VCA → Comparison and Modeling → Face Comparison and Modeling .
2.
Select Face Picture Comparison.
3.
Check Enable Face Picture Comparison.
4.
Select a face picture library as the reference.
5.
Select desired face
informaon to upload.
6.
Select a face comparison mode.
Best
Comparison
The device captures and compares the target face connuously when the
face target stays in the detecon area, and upload the best scored face
picture and related alarm informaon when the target face leaves the area.
Quick
Comparison
The device capture and compares the target face when the face grading
exceeds the set Face Grading Threshold for Capture.
Face Grading Threshold for Capture
The face grading threshold for the device to judge whether to capture and
upload the face or not.
Max. Capture Interval
The max. interval between two captures when the target is in the
detecon area. The camera takes the capture when it reaches the max.
interval even if the face grading does not reach the set threshold.
Quick Setup Mode
Network Speed Dome User Manual
18

HIKVISION DS-2DF8C435MHS-DELW Specifications

General

Brand	HIKVISION
Model	DS-2DF8C435MHS-DELW
Category	Security Camera
Language	English